1967 - 1969 Camaro Aluminum Radiator - Dual Fans - 1-1/4" Tubes

Product Code: 9370-HD-DF

 

If you're reading this, then you probably have a serious Camaro with a serious high horsepower big block. Though, this radiator will fit small block cars too, it's made for serious cooling in 600 - 900 horsepower applications.

The camaro has a lot of things going for it when it comes to cooling options. For a small block, you can fit just about any motor and accessory drive, including the Vintage Air and March serpentine systems, without having to get creative with making it all fit. 

Regardless if your camaro was an original 6 cylinder car, small block car or big block car, this radiator will fit bolt right into your Camaro. For small block powered cars, it will fit with a v-belt, serpentine drive, long water or short water pump: it will fit with ease. 

This radiator fan setup will fit with any small block configuration imaginable, including 8-71 blower cog drives.

To keep your camaro running extra cool with killer stylking, this Camaro radiator uses our  11" HPX fans. Completely engineered by us with a die formed aluminum housing, these fans were specially engineered by us to deal with your typical modern day problems: lots of horsepower, tight clearances, Vintage Air and the need for killer styling.  

They pull over 1500 CFM each and look KILLER doing it. Not only do they move a ton of CFM, they add modern day styling to your hot rod. CFM alone isn't the whole story. These fans were designed to keep the CFM from falling off when having to pull through thick cores and A/C condensers at the same time.

Many electric fans are living 30 years in the past and can't handle the horsepower and A/C requirements of today. These fans will bring your ride into the modern day.

 

To make everything fit with your big block and billet accessory drive, we specially configure the fans on that model to clear the trouble spots that cause intereference problems on big blocks. Typically the power steering pump and the A/C compressor with serpentine systems. 

 

Features:

 

- 1-rows of 2" cooling tubes

- Cooling power for 600 - 900 horsepower

- Dual 11" HP fans for a total 3000 CFM under heavy loads

- Precision TIG welded construction

- Lifetime warranty

- Billet CNC machined filler neck

- Heavy duty plate transmission cooler

- Stainless steel hardware

 

Like all of our radiators, it's made in the USA. We guarantee you'll think it's sexy and guarantee it to cool your car with ease. And of course our lifetime warranty on everything: radiator and fans. 

 

 

For fan control, you can use our FC02 dual fan controller.

For somerhing more sophisticted, you can use our FC03 fan controller. It allows you to run the fans at both and a low speed versus just an ON/OFF setting.

The FC03 controller is also great for v-belt cars with lower powered alternators. It will make sure your alternator isn't hammered hard when the high powered fans go to work to cool your engine down. 

$1,060.00
Customer Reviews
This product hasn't been reviewed yet. Write a review

eCommerce Software by CubeCart